Start inside, not outside
Choose the height you plan to fill. Measure inside the container at that line and from the inside base up to that line. This keeps the wall thickness and any empty space above the mix out of the geometry estimate.
Choose the closest supported shape
Use rectangular for straight-sided boxes, cylinder for straight-sided round pots, and tapered round for circular pots with straight sides that narrow toward the base. Curved, bulging or divided containers are not modeled exactly; use a documented usable capacity when available, or treat the geometry result as approximate.
For a tapered pot, measure twice across
Enter the inside diameter at the intended fill line and the inside diameter at the bottom. Both measurements go all the way across, not from the center to the edge. Then enter the filled depth. The method assumes a circular cross-section and a straight taper.
Keep bag units explicit
Use the volume stated on the bag. The tool accepts liters, cubic feet, explicitly identified US liquid gallons and explicitly identified US dry quarts, including the Espoma AP8 preset. It does not interpret an unspecified quart or gallon, Imperial gallons, nursery trade sizes or mass as a known usable volume. Match the bag’s stated unit exactly.
Sources
This guide draws on the following unit references.
- NIST: SI Units — Length — checked 2026-10-17
- NIST: SI Units — Volume — checked 2026-10-17
- NIST: How Do You Measure Fuel at the Gas Pump? — checked 2026-10-17